Chapter 3 Installing the Router
Configuration Changes

3-54

Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03

The output shown in this example depends on the image version of the Cisco IOS

software and the way your router is equipped. Your configuration dialog might be

different.

The setup command script is a self-guiding interactive script that prompts you for

responses and provides default or alternative values wherever possible.

setup Command Interactive Script Example
Cisco Internetwork Operating System Software
.
.
.
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]: Yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic setup only configures enough connectivity
for management of the system, extended setup will ask you
to configure each interface of the system.
Would you like to enter basic management setup? [yes/no]: Yes
Configuring global parameters:
Enter host name [Router]: Router
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret [<Use current secret>]: alpha
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: bravo
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: charlie
Configure SNMP Network Management? [no]: