Chapter 5 Field Diagnostics for the Cisco 12000 Series Router
Using Diagnostics
5-6
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03
Field Diag eeprom values: run 8 fail mode 0 (PASS) slot 0
last test failed was 0, error code 0
Shutting down diags in slot 0
Board will reload
Router#
Router#
Router#
SLOT 0:00:00:42: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) GS Software (GLC1-LC-M), Experimental Version
12.0(20030909:221642) [hsiang-conn3 108]
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Thu 11-Sep-03 15:19 by hsiang
Using Diagnostics
Before proceeding with any diagnostics procedures, review the following:
• Obtain and Place the Diagnostics Image, page 5-6
• Upgrade the FPGA Image on a Line Card, page 5-7

Obtain and Place the Diagnostics Image

Before you can use the line card field diagnostics commands, you must obtain and
place a valid diagnostics image on a separate Flash memory card installed in the
router or on a TFTP boot server.
Field diagnostics images are approximately 18 MB in size. Cisco IOS images are
slightly larger. A single 64-MB Flash memory card can contain both images, or
these images can be stored individually on two 20-MB memory cards inserted into
in card slot 0 and slot 1 on the RP. To accommodate future feature releases, it is
recommended that you use larger Flash memory disks.
The diagnostics image is named c12k-fdiagsbflc-mz.120-25.S and is always
available on Cisco.com. 120-25.S is the version number of the image that
corresponds to the Cisco IOS image, in this example, Cisco IOS Release
12.0(25)S.