Cisco Systems Cisco 12406 Reconnecting Cables to the Replacement Chassis, Reconnecting RP Cables

Chapter 6 Maintaining the Router

Removing and Installing the Chassis

Installing the Chassis in the Equipment Rack

Before removing the chassis from the equipment rack, you determined how the chassis was mounted in the rack:

•Mounted directly against the rack flanges, but sitting on the optional rack-mounting brackets (see Figure 3-1 on page 3-4)

•Mounted directly against the rack flanges

•Mounted using the center-mount bracket kit (see Figure 3-2 on page 3-5)

Use the same mounting arrangement and install the replacement chassis as instructed in the “Installing the Chassis in a Rack” section on page 3-7.

Reattaching the Supplemental Bonding and Grounding Cable

Reattach the bonding and grounding cable lugs to the bonding and grounding receptacles as described in the “Supplemental Bonding and Grounding Connections” section on page 3-9.

Reconnecting Cables to the Replacement Chassis

This section explains the following procedures:

•Reconnecting RP Cables, page 6-76

•Reconnecting Alarm Cards Cables, page 6-76

•Reconnecting Line Card Network Interface Cables, page 6-77

Reconnecting RP Cables

Reconnect the cables to the RP as instructed in the “Connecting RP and Line Card Cables” section on page 3-11.

Reconnecting Alarm Cards Cables

Reconnect the cables to the alarm cards as instructed in the “Connecting Alarm Card Cables” section on page 3-13.

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
6-76	OL-11497-03