Cisco Systems Cisco SFS 7000P manual Removing a Pinch Connector

Chapter 2 Installing the Cisco SFS 7000P Switch

Connecting Network Devices

Note If your host does not provide an ample amount of space around an IB port, double-check that your IB cable connector engages fully. Move your connector back and forth to be sure that both sides of the connector have locked firmly into place.

b.To remove a cable with a pinch connector, pinch both sides of the back of the connector and pull the connector away from the port (see Figure 2-11).

Figure 2-11 Removing a Pinch Connector

Press here

Press here

144962

c.To remove a cable with a pull connector, grasp the connector with one hand and push it toward the port, then pull the latch away from the port with your other hand and gently move the connector back and forth and away from the port (see Figure 2-12).

	Cisco SFS 7000P Hardware Installation Guide
2-14	OL-9167-01 Rev. A0