Appendix C RAID Controller Considerations
Enabling the Mezzanine Card RAID Controller in the BIOS
Enabling the Mezzanine Card RAID Controller in the BIOS
When using the supported
Step 1 Make sure that a RAID cable is attached between the mezzanine card and the disk backplane. Step 2 Boot the server and press F2 when prompted to enter the BIOS Setup utility.
Step 3 Select the Advanced tab, then Mass Storage Controllers Configuration.
Step 4 Set Onboard SATA Controller to Enabled.
Step 5 Set SATA Mode to Enhanced.
Step 6 Press F10 to save your changes and exit the BIOS Setup utility.
Step 7 To set up a RAID configuration when using the mezzanine card, boot the server and press
RAID Controller Cabling
The possible RAID controller connectors in this server are shown in Figure
Note The Cisco UCS C200 SFF server is shown, with an
Figure C-1 RAID Controller Connectors
| 4 |
1 |
|
2 | 3 |
|
|
|
|
|
| 332177 |
|
|
|
|
|
|
|
|
|
| ||||
1 | Drive backplane | 3 | Mezzanine card connector(s) | ||||||
|
|
|
|
|
| ||||
2 | Integrated RAID connector on | 4 | LSI MegaRAID PCIe card connectors | ||||||
|
|
| motherboard |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Cisco UCS C200 Server Installation and Service Guide |
|
|
| |
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| |||
