iDP3420/3421/3423 User ’s Manual
ESC "u" n
[Function] | Sending the status for peripheral device | ||
[Code] | <1B>H <75>H n |
| |
[Range] | n = 0 |
| |
[Outline] | This commands sends the status of the connector no. 3 pin. | ||
|
|
|
|
|
| n | Connector Pin |
0Drawer
Status Sent
Bit | Function |
| Value | |
0 |
| 1 | ||
|
|
| ||
0 | No. 3 pin's level | “LOW” |
| “HIGH” |
1 | Undefined |
|
|
|
2 | Undefined |
|
|
|
3 | Undefined |
|
|
|
4 | Undefined |
|
|
|
5 | Undefined |
|
|
|
6 | Undefined |
|
|
|
[Caution] | This command is valid only for the serial interface. If nothing is connected to the connector, |
| the bit 0 will be always "1". In case of DTR/DSR control, if the host cannot receive (DSR |
| signal has the Mark status), the printer will wait until it will be ready to receive. In case of |
| XON/XOFF control, only one byte will be sent without confirming the status of the DSR |
| signal. Note that it may take time to send the status after receiving the command. |
105 | CITIZEN |
