Clover Electronics LCD22164 Sensor Connection and Relay in &OUT Sensor Connection Sensor

Stand-alone DVR Instruction Manual

(screen) as shown [Fig.5-4-2].

-Attach the mounting bracket to the desired location on the wall. Locate wall studs and securely fix the mounting bracket with the supplied screws.

Note:

-Pay attention to not make scratches or dents on the surface of panel (screen) during installation of the system.

-In case of this, the warranty will be voided.

5-4.2.1. Connection of Composite Monitor

If necessary, connect the composite Video Output (yellow RCA) and Audio Output (white RCA) to Video IN and Audio IN on a composite monitor or TV (RCA cable: not included).

5-4.3. Sensor Connection and RELAY IN &OUT

▫SENSOR Connection (SENSOR IN)

Connect up to 8 sensors to ALM (SENSOR) IN. The Sensors should be contactor type and support N.O. (Normal Open).

[Fig 5-5 SENSOR IN PIN]

▫ALARM OUT Connection

When necessary, use ALARM OUT. The ALARM OUTPUT is a relay contactor type and supports N.O. (Normal Open) and N.C. (Normal Close). The Output capacity is 220V 1A. A higher capacity can cause system failure.

RS-485

[Fig 5-5]

[Fig 5-6 Alarm Output]

26