Compaq AA-Q88CE-TE manual Log

LOG

LOG

Specify RTR to write a log message to a log file.

Format

LOG

Command Qualifiers	Defaults
/CLUSTER	/NOCLUSTER
/NODE=node-list	/NODE=default-node-list
/OUTPUT[=file-spec]	/OUTPUT=stdout

Description

The LOG command specifies a defined log entry to be written to its log messages. You can write log messages to the operator console and to a maximum of four log files. Log files must be periodically purged to avoid difficulties with full disks. Do this by using SET LOG to specify a new file and deleting the old one.

If neither the /OPERATOR nor the /FILE qualifier is specified then logging is suppressed.

Qualifiers

/CLUSTER /NOCLUSTER (D)

Specifies that the command is executed on all the nodes in the cluster.

If neither /NODE nor /CLUSTER is specified then the command is executed on the nodes specified by the latest SET ENVIRONMENT command. If no SET ENVIRONMENT command has been entered then the command is executed only on the node where the command was issued.

Note: In environments that do not support clustering, use of the /CLUSTER qualifier will cause the relevant command to be executed on the local node only.

/NODE[=node-list] /NODE=default-node-list (D)

Specifies that the command is executed on all nodes specified in node-list. If node-listis omitted then the command is executed only on the node where the command was issued.

/OUTPUT[=file-spec] /OUTPUT=stdout (D)

Specifies that the resulting information is written to the file file-spec. If /OUTPUT or file-specis omitted then the standard or default output is used.

Related Commands

•SHOW LOG

6–96RTR Command Line Interface