SHOW FACILITY

SHOW FACILITY

Show the names, configuration and status of one or more facilities.

Format

SHOW FACILITY [facility-name]

Command Qualifiers

Defaults

/BALANCE

/NOBALANCE

/CLUSTER

/NOCLUSTER

/CONFIGURATION

/NOCONFIGURATION

/COUNTER[=counter-name]

/NOCOUNTER

/FULL

/NOFULL

/LINKS

/NOLINKS

/STATE

/NOSTATE

/OUTPUT[=file-spec]

/OUTPUT=stdout

/NODE[=node-list]

/NODE=default-node-list

Description

The SHOW FACILITY command shows the names, configuration and status of facilities on the node where the command is executed. If no qualifiers are used, only the facility name or names and the roles in the facility on the node are displayed.

Parameters

facility-name

Specifies the name of the facility you want to display. Facility-namemay contain wild cards ("*" and "%"), in which case all matching facilities will be displayed. If facility-nameis omitted all configured facilities are displayed.

Qualifiers

/BALANCE /NOBALANCE (D)

Specifies that the load-balancing status of the facility is also displayed. See Section 2.6, Router Load Balancing for details of load-balancing.

/CLUSTER /NOCLUSTER (D)

Specifies that the command is executed on all the nodes in the cluster.

If neither /NODE nor /CLUSTER is specified then the command is executed on the nodes specified by the latest SET ENVIRONMENT command. If no SET ENVIRONMENT command has been entered then the command is executed only on the node where the command was issued.

Note: In environments that do not support clustering, use of the /CLUSTER qualifier will cause the relevant command to be executed on the local node only.

6–136RTR Command Line Interface

Page 212
Image 212
Compaq AA-Q88CE-TE manual Show Facility facility-name, Facility-name