Creative GCD-R542B manual Installing the Software, Fastening the drives to your system

6.Slide the drives back into place and fasten them to your system as shown in Figure 2-23.

Figure 2-23: Fastening the drives to your system.

7.Switch on your system.

8.Proceed to install the software.

Installing the Software

The following instructions show you how to install two drivers required to control your CD-ROM drive and an application that allows you to play audio CDs.

To install the software:

1.Insert the CD-ROM Installation Disk into drive A or B of your computer.

2.Type A:INSTALL (or B:INSTALL) and press <Enter>.

3.Follow the instructions on the screen to complete the installation.

If you are connecting your drive to the hard disk controller card, select 1F0 for the I/O address.

Setting Up Your CD-ROM Drive 2-17