Dell 7330 manual Enabling IPv6

IPv6

IPv6

This section includes:

■Enabling IPv6 on page 3-25

■Setting the Interface ID on page 3-26

■Automatic Address Assignment on page 3-27

■DHCPv6 on page 3-28

■Manual Address Assignment on page 3-29

■Address Precedence on page 3-30

Enabling IPv6

IPv6 can be enabled or disabled independently of IPv4.

Note: If you disable both IPv4 and IPv6, you will lose your connection to the printer. For information on restoring the default TCP/IP settings, see Resetting the TCP/IP Configuration on page 3-26.

To enable/disable IPv6, use one of the following options:

■The printer’s control panel

■Embedded Web Server

Using the Control Panel

To enable/disable IPv6 on the control panel:

1.Select Printer Setup, and then press the OK button.

2.Select Connection Setup, and then press the OK button.

3.Select Network Setup, and then press the OK button.

4.Select TCP/IPv6 Setup, and then press the OK button.

5.Select IPv6, and then press the OK button to switch between On and Off.

Using the Embedded Web Server

To enable/disable IPv6 using EWS:

1.Launch your web browser.

2.Enter your printer’s IP address in the browser’s Address field.

3.Click Properties.

4.Select the Protocols folder on the left navigation panel, and then click TCP/IP.

5.Click the TCP/IP (v6) button.

6.Select the TCP/IP v6 Enabled check box to enable TCP/IP v6.

7.Click the Save Changes button at the bottom of the page.

Dell 7330 Mono Laser Printer

3-25