Dell DCMA owner manual Cards, Removing Memory, 111

8Right-click the My Computer icon and click Properties.

9Click the General tab.

10To verify that the memory is installed correctly, check the amount of memory (RAM) listed.

Removing Memory

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

CAUTION: Before removing memory, you must remove the PCI Express x16 card. See "Cards" on page 111.

NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. You can do so by touching an unpainted metal surface on the computer chassis.

1Follow the procedures in "Before You Begin" on page 97.

2Press out the securing clip at each end of the memory module connector.

3Grasp the module at the end of the board and lift up.

4Replace the PCI Express x16 card (see "Cards" on page 111).

Cards

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. You can do so by touching an unpainted metal surface on the computer chassis.Your Dell™ computer provides the following slots for PCI and PCI Express cards:

•One PCI Express x16 card slot (SLOT1)

•One PCI Express x1 card slot (SLOT2)

•Two PCI card slots (SLOT3, SLOT4)

See "System Board Components" on page 102 for card slot location.

Removing and Installing Parts

111