148 Removing and Installing Parts
7
Tighten the two screws to secure the floppy drive.
8
Attach the power and data cables to the floppy drive.
9
Connect the other end of the data cable to the connector labeled
"FLOPPY" on the system board (see "Inside View of Your Computer" on
page109) and route the cable through the clip on the shroud.
NOTE: The location/connectors may vary depending on your system type. For more
information, see "System Board Components" on page110.
10
Check all cable connections, and fold cables out of the way to avoid
blocking airflow between the fan and cooling vents.
11
Replace the bezel (see "Replacing the Bezel" on page137).
1floppy drive 2data cable 3power cable
4system board
connector
5custom screws (2) 6screw holes in the
floppy drive
2
4
3
1
5
6
book.book Page 148 Monday, October 6, 2008 11:28 AM