Dell R610 owner manual iDRAC6 Enterprise Card Optional, Installing a VFlash Media Card

Installing a VFlash Media Card

1Locate the VFlash media slot at the back corner of the system. See "Back- Panel Features and Indicators" for the location of the media slot.

2With the label side facing up, insert the contact-pin end of the SD card into the card slot on the module.

NOTE: The slot is keyed to ensure correct insertion of the card.

3Press inward on the card to lock it into the slot.

Removing a VFlash Media Card

To remove the VFlash media, push inward on the card to release it, and pull the card from the card slot.

iDRAC6 Enterprise Card (Optional)

Installing an iDRAC6 Enterprise Card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System."

3Remove the plastic filler plug from the system back panel.

4If installed, remove the expansion card from expansion-card riser 1. See "Removing an Expansion Card."

5Install the iDRAC6 Enterprise card:

a Angle the card so that the RJ-45 connector fits through the back-panel opening. See Figure 3-12.

b Align the front edge of the card with the two front plastic retention standoffs next to the iDRAC6 connector on the system board, and lower the card into place. See Figure 3-12 and Figure 6-1.

Installing System Components

101