Dell R610 owner manual Installing the PERC 6/I Battery Cable

3Disconnect the battery cable from the PERC controller. See Figure 3-17 for the battery connection location.

NOTE: Pay attention to the routing of the cable in the chassis for reinstallation.

4Remove the battery cable from the cable clip on the system board nearest PSU #2.

5Follow the cable along the inside wall of the chassis.

6Remove the fan bracket. See "Removing the Fan Assembly" on page 106.

7Remove the fan cable from the plastic cable routing guide. It might be necessary to remove other cables from the routing guide.

8Disconnect the battery cable from the RAID battery.

Installing the PERC 6/I Battery Cable

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System."

3Remove the fan bracket. See "Removing the Fan Assembly" on page 106.

4Connect the battery cable to the RAID battery.

5Route the battery cable on the inside of the chassis wall through the plastic cable routing guide. If any other cables were removed from the routing guide, route those cables through the routing guide as well.

6Route the cable on the inside of the chassis wall, place the cable in the cable clip nearest PSU #2.

7Route the cable to the PERC controller and connect it to the battery connector on the PERC controller.

8Replace the fan bracket. See "Replacing the Fan Assembly" on page 107.

9Close the system. See "Closing the System."

10Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Installing System Components

115