Dell R610 owner manual Internal SD Module, Replacing an Expansion-Card Riser

1	expansion-card riser 2	2	retention latch
3	expansion card slot 2	4	riser guide posts (2 per riser)
5	expansion-card riser socket	6	expansion card slot 1
7	expansion-card riser socket	8	integrated storage controller slot (on
			opposite side of riser)
9	expansion-card riser 1

Replacing an Expansion-Card Riser

1To install an expansion-card riser, align the board with the riser guide posts on the system board. See Figure 3-9.

2Lower the expansion-card riser into place until the expansion-card riser connector is fully seated.

3If applicable, reinstall the expansion card. See "Installing an Expansion Card."

4If you are installing expansion-card riser 1, reinstall the integrated storage controller card. See "Installing the Integrated Storage Controller Card."

5Close the system. See "Closing the System."

6Reconnect the system and peripherals to their power sources.

Internal SD Module

Installing the Internal SD Module

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System."

Installing System Components

95