Dell R610 owner manual Power Supplies, Removing a Power Supply

Power Supplies

Your system supports the following power supply modules:

•717-W High Output power supply

•502-W Energy Smart power supply (the default power supply option for this system)

NOTE: The system does not support a mixed installation of High Output and Energy Smart power supplies.

If only one power supply is installed, it must be installed in the PS1 power supply bay.

Removing a Power Supply

CAUTION: To ensure proper system cooling, the power supply blank must be installed in power supply bay PS2 in a non-redundant configuration. See "Removing the Power Supply Blank."

CAUTION: If troubleshooting a PSU mismatch error, replace only the power supply with the flashing indicator. Swapping the opposite power supply to create a matched pair can result in an error condition and unexpected system shutdown. To change from a High Output configuration to an Energy Smart configuration or vice versa, you must power down the system.

1Disconnect the power cable from the power source and the power supply you intend to remove and remove the cables from the Velcro strap.

2Press the lever release latch and slide the power supply out of the chassis. See Figure 3-7.

NOTE: You may have to unlatch and lift the optional cable management arm if it interferes with power-supply removal. For information about the cable management arm, see the system’s rack documentation.

Installing System Components

87