Dell R610 owner manual Control Panel Assembly, Removing the Control Panel Display Module

8Enter the System Setup program to confirm that the battery is operating properly. See "Entering the System Setup Program."

9Enter the correct time and date in the System Setup program's Time and Date fields, and configure the other settings for your system.

10Exit the System Setup program.

Control Panel Assembly

NOTE: The control panel assembly consists of two separate modules—the display module and the control panel circuit board. Use the following instructions to remove and install either module.

Removing the Control Panel Display Module

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

11Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and peripherals.

12Open the system. See "Opening the System."

13Disconnect the display module cable from the control panel board. See Figure 3-22.

14Using a knife or a small flat-blade screwdriver, insert the blade beneath the front panel of the display and slide the blade across the bottom to lift the panel outward. See Figure 3-22.

15Bend the panel upward to allow access to the mounting screws.

Installing System Components

129