Dell T3400 manual Attach the screws to the new drive 222

7Slide the sliding-plate lever to the right to release the shoulder screw and slide the drive or Media Card Reader out of the 3.5-inch drive bay.

Installing a Floppy Drive or Media Card Reader (Tower Computer)

NOTICE: In a tower configuration with 4 hard drives, there can only be one floppy drive or Media Card Reader which must be installed in the lower 3.5-inch drive bay. In this case, the 4th hard drive (which must be a SATA drive) will occupy the upper 3.5-inch drive bay.

1Follow the procedures in "Before You Begin" on page 143.

2Remove the computer cover (see "Removing the Computer Cover" on page 145).

3Remove the front panel (see "Removing the Front Panel" on page 154).

4If you are installing a new floppy drive or Media Card Reader, remove the drive-panel insert (see "Removing a Drive-Panel Insert" on page 218) and remove the shoulder screws from the inside of the drive-panel insert.

Attach the screws to the new drive.

222

Adding and Replacing Parts