Dell T3400 manual Removing the System Board

4On the desktop computer, reattach the power cables to the side of the hard drive.

5Run the cables underneath the tabs, and press the tabs to close them over the cables.

6Replace the computer cover (see "Replacing the Computer Cover" on page 262).

NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.

7Connect your computer and devices to electrical outlets, and turn them on.

System Board

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.

NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. You can do so by touching an unpainted metal surface on the computer.

NOTICE: The system board and metal tray are connected and are removed as one piece.

Removing the System Board

1Follow the procedures in "Before You Begin" on page 143.

2Remove the computer cover (see "Removing the Computer Cover" on page 145).

3Remove the front panel (see "Removing the Front Panel" on page 154).

4Remove any components that restrict access to the system board.

5Disconnect all cables from the system board.

6Before you remove the existing system board assembly, visually compare the replacement system board to the existing system board to make sure that you have the correct part.

258

Adding and Replacing Parts