General Installation Guidelines

When you install a drive, you connect two cables—a DC power cable and a data cable—to the back of the drive. The DC power cable is connected to the power supply while the other end of the data cable connects an expansion card or the system board. Most connectors are keyed for correct insertion (a notch or a missing pin on one connector correspondes to a tab or a filled-in hole on another connector).

When connecting a SAS or SATA cable, hold the cable by the connector at each end and press firmly into the connector. When disconnecting a SAS or SATA cable, hold the cable by the connector at each end and pull until the connector detaches.

Power Cable Connectors

2

2

 

1

1

 

1

power cable

2

power input connector

Adding and Replacing Parts

189

Page 189
Image 189
Dell T3400 manual General Installation Guidelines, Power Cable Connectors, 189, Power cable