NETWORK menu
NETWORK menu
Remember that incorrect network settings on this projector may cause trouble on the network. Be sure to consult with your network administrator before connecting to an existing access point on your network. Select “NETWORK” from the main menu to access the following functions.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor button on the projector or remote control, or ENTER button on the remote control to execute the item. Then perform it according to the following table.
See the User’s Manual - Network Guide for details of NETWORK operation.
NOTE • If you are not utilizing SNTP (Date/Time Settings in the User ’s Manual - Network Guide), then you must set the DATE AND TIME during the initial installation.
•The network communication control is disabled while the projector is in standby mode if the STANDBY MODE item of SETUP menu is set to SAVING.
Please connect the network communication to the projector after setting the STANDBY MODE to NORMAL (46).
Item |
| Description |
|
|
|
| Selecting this item displays the SETUP | |
| Menu for the network. | |
| Use the ▲/▼ buttons to select an item, | |
| and the ► or ENTER button on the remote | |
| control to perform the item. | |
|
|
|
|
| Use the ▲/▼ buttons to turn DHCP on/off. |
SETUP |
| ON OFF |
| Select OFF when the network does not have | |
|
| |
| DHCP | DHCP enabled. |
| (Dynamic Host | • When the “DHCP” setting changes to “ON”, it |
| Configuration | takes a little time to obtain IP address from DHCP |
| Protocol) | server. |
|
| • Auto IP function will be assigned an IP address if |
|
| the projector could not obtain an IP address from |
|
| server even if DHCP is “ON”. |
(continued on next page) |
| |
66
