Presentation tools
Interactive Function (continued)
Connection during use
Follow the procedure below to connect the computer to the projector.
Computer
USB | DISPLAY |
(A) |
USB
TYPE A 
DC5V
0.5A
LAN 
USB TYPE B | HDMI | COMPUTER IN2 |
| IN1 |
| MIC | AUDIO IN1 AUDIO IN3 | AUDIO OUT |
CONTROL | MONITOR OUT | R | R |
|
| L | L |
|
| AUDIO IN2 | VIDEO |
(1)Connect the computer cable to the COMPUTER IN port of the projector, and fasten using the screw.
(2)Connect the opposite end of the computer cable in (1) to the DISPLAY port of the computer, and fasten using the screw.
(3)Connect the USB TYPE B port of the projector to the USB type A port of the computer with a USB cable.
(4)Connect the power supply of the projector and computer.
NOTE • When Interactive Function is in use, it is recommended that you make use of input signals from the COMPUTER IN1 and COMPUTER IN2 ports. Optimal performance cannot be achieved using input signals from the USB TYPE B and LAN ports.
•Noise through the USB cable may trigger a malfunction depending on the computer and projector you are using. When this occurs, check to ensure that the power cables of the computer and projector are grounded. Malfunction may occur if the cables are not grounded.
•The pen sensor may be blocked if the projector is placed directly on the
floor. It is recommended the projector be mounted on the wall or ceiling. The Interactive Function does not work during rear projection.
CAUTION ►Be careful of the wired cables. Tripping over the cables may result in injury or damage the projector or computer.
81
