TRANSCEIVER OPERATION
2-22
November 1999
Part No. 001-7780-500
2.7.4 CHANNEL CHANGE PARAMETER
The “CHAN CHG” menu parameter selects the
conventional channelto be reprogrammed. Disabled or
SMARTNET/SmartZone channelsc annotbe selected.
This does not change the channel selected for normal
operation.
Enter the channel number or scroll through the
programmed channels by pressing the and
keys. When the desired channel is displayed,select it
by pressing the ENT key.
2.7.5 SYSTEM PARAMETERS
The “SYS PRM” menu parameter selects th e
conventional mode timer to be reprogrammed (see
following). Press the an d keys to display the
desired timer and then pressthe ENT keytoselectit.
SCAN TMR - Selects the Scan Hold timer.Press
the and keys to decrement/increment the
timer in 0.5-second steps, and pressthe “0” key to
disable the timer (set it to 0 seconds). When the
desired value is displayed,store it by pressing the
ENT key.
TX TMR - Selects the transmit time-out timer.
Press the and keys to decrement/increment
the timer in 15-second steps,and press the “0” key
to disable the timer (set it to 0 seconds). When the
desired value is displayed, press the ENT key to
store it.
PEN TMR - Selects the penalty timer.Press the
and keys to decrement/incrementthe timer
in 15-second steps, and press the “0” keyto disable
the timer (set it to 0 seconds). When the desired
value is displayed, store itby pressing the ENT
key.
CONV TMR - Selects the conversation timer.
Press the and keys to decrement/increment
the timer in 30-second steps,and press the “0” key
to disable the timer (set it to 0 seconds). When the
desired value is displayed,store it by pressing the
ENT key.
2.7.6 CHANNEL PARAMETERS
The “CHAN PRM” menu parameter selects the
conventional channel parameter to be reprogrammed
(see following). Press the and keys to display
the desired parameter and then press the ENT key to
select it.
RX FREQ - Selects the receive channelfrequency.
Press the and keys to move the cursor left
and right, and press the 0-9 keysto enter a digit.
When the desired frequency is displayed, storeit
by pressing the ENT key.
TX FREQ - Same as RX FREQ above.
RX CODE - Selects the receive CallG uard
(CTCSS/DCS) code. Press the “0” key to display
the first available code, and press it again to toggle
between types (CTCSS and DCS). Press the
and keys to scroll through the available codes.
When the desired code is displayed, store it by
pressing the ENT key.
TX CODE - Same as RX CODE above.
TX POWER - Selects the desired power output
level. Press the and keys to scroll through
the following choices. When thedesired setting is
displayed, store it by pressingthe ENTkey.
•POWER HI - High transmit power
•POWERLO-Lowtransmitpower
•POWER SW - Switchable power selectable by
the High/Low power switch.This choice is not
available if that switch is not programmed.
TX TMR - Enables or disables the time-out timer
on the current channel. Press the and keys
to toggle between the on and off mode,and when
the desired setting is displayed, store itby press ing
the ENT key.