3-1 November 1999
Part No. 001-7780-500
TRANSCEIVER PROGRAMMING
SECTION 3 TRANSCEIVER PROGRAMMING
Figure 3-1 Programming Setup
Remote Programming Interface (RPI)
Part No. 023-9800-000
RPI-Transceiver
Programming Cable
Part No. 597-2002-123
3.1 GENERAL
3.1.1 PROGRAMMING SETUP
The following items are required to progr am the
transceiver and control unit. Thepart n umbers of this
equipment are shown in Table1-1 in Section 1. The
programming set-up is shown above.
•IBM® PC or compatible personal com puter
•Remote Prog. Interface (RPI) P.N. 023-9800-000
•Cables from the RPI to the computer and
transceiver
•EFJohnson PCTrunk programmingsoftware.
3.1.2 COMPUTER DESCRIPTION
The computer used to run this programshould
meet the following minimum requirements:
•Windows® 3.1, 95/98, or NT 3.51
•Intel® 486 processor or equivalent
•At least 4 MB of RAM
•A hard disk drive with at least 5 MB of free space
•An available serial port
NOTE: With the descriptionswhich follow, it is
assumed that you have a basic understandingof how
to use your Windows-basedoperating system. If you
are not familiar with some of the Windowsfunctions
described, refer to your Help Screensand manuals
included with your Windowssoftware.
3.1.3 PCTRUNK SOFTWARE INSTALLATION
The PCTrunk software is supplied on two 3-1/2”
diskettes. Install this softwareas follows:
1. Make sure that there are no other Windows applica-
tions open during this installationprocedure. Also,
make sure that the computer meets the minimum
requirements listed in the precedingsection.
2. Insert PCTrunk Disk 1 inthe disk drive of your
computer.
3. Windows 3.1 or NT - In the Program Manager,
double click the SETUP.EXEfile on PCTrunk Disk
1 or click this file name and select File > Run.