TRANSCEIVER PROGRAMMING

Figure 3-3 Conventional Channel Screen

3.5.4CONVENTIONAL CHANNEL SCREEN PARAMETERS

The following parameters are programmed in the conventional channel screen shown in Figure 3-3.

Selected Channel

Zone Box - Clicking the arrow to the right of this box displays the available zones. Click on a zone to select it. Zones and zone aliases are set up on the Radio- Wide General screen described in Section 3.4.2.

Channel Index Box - Displays the available channels in the selected zone. The channel type is selected by the Channel Type box below it.

Modify Button - Displays the screen that follows which enables the channel (makes it select- able) and programs the alias (tag) and transmit and receive frequencies.

The parameters in this screen are as follows:

Channel - Selects the channel to be edited.

Alias - Programs the identification that is displayed when the channel is selected. Up to 8 characters can be programmed.

Transmit - Programs the transmit frequency of the channel.

Receive - Programs the receive frequency of the channel.

Enable This Channel - The box must be checked for the channel to be selectable.

Rx Only - The box is checked if the channel is receive-only (transmitter disabled).

Copy Parameters From Channel - If another channel is selected, the parameters from that chan- nel are copied to the new channel.

November 1999

 

Part No. 001-7780-500

3-12

Page 48
Image 48
EFJohnson 7780 service manual Conventional Channel Screen Parameters, Selected Channel