Electro-Voice 1252 Using Psio with Multiple I/O Modules, Steps for Attaching Multiple I/O Modules

9.3: Using PSIO with Multiple I/O Modules

	LEDs	Communication
		ONLY
Female		(A+, B- and
RS-485		Shield)

Side Port

Control

Power

Reset Button

Mounting Bracket

I/O Port (Size and pin configuration vary)

Figure 9.6: Using PSIO with Multiple I/O Modules

NOTE: PSIO must be to the right of I/O Modules when viewing the side label (as shown).

9.3.1: Steps for Attaching Multiple I/O Modules

1.Each I/O module in a group must be assigned a unique address. See the Communicator EXT User Manual for details on configuring and programming the I/O Modules.

2.Determine how many power sources (such as PSIO) are needed for the number of modules in use. See section 9.2.1 for details.

3.Starting with the left module and using a slotted screw driver, fasten the first I/O Module to the left Mounting Bracket. The left Mounting Bracket is the one with the PEM. Fasten the internal screw tightly into the left Mounting Bracket.

4.Next, slide the female RS-485 port into the male RS-485 side port to connect the next I/O module to the left module. Fasten together enough to grab but do not tighten.

One by one combine the modules together using the Integrated Fastening System (Fig. 9.1). If you require an additional power supply, attach a PSIO (power supply) to the right of each group of 4 I/O Modules (section 9.3).

Electro Industries/GaugeTech Doc # E107706 V1.25 9-5