Alarm Limits | Enterasys Networks IRM2 specs

Alarm Limits

5.Repeat steps 1-4 for each type of alarm you wish to configure.

6.Click on to save the configuration, then click Cancel to close the

window. Be sure to click on before closing the window, or your changes will not be saved.

Your Alarm Limits are now set. Any condition that exceeds these alarm limits will generate an alarm, and disable that board or port, if so configured.

Refer to your Enterasys’Alarm and Event Handling User’s Guide for information on how to use its alarm logging facilities to view alarms.

5-8	Configuring Alarms

Image 68

Enterasys Networks IRM2 manual Alarm Limits

Contents

IRM2 Users Guide Page Virus Disclaimer Page Restricted Rights Notice Page Contents Chapter Trap Selection Statistics Chapter Redundancy Index Contents Viii Using This Manual Introduction Related Manuals Introduction Using the Mouse Software Conventions Common IRM2 Window Fields Device Name Using Window Buttons Using On-line Help Getting Help Getting Help from the Enterasys Global Call Center Hours a day, 365 days a year Introduction Getting Help IRM2 Chassis View Viewing Chassis Information Front Panel Information Port Locking/UnlockingConnection Status Port Status Boot Prom Menu StructureFirmware Time IRM2 Chassis View Menu Structure Device Menu Repeater Menu View MenuPort Status Menu Board Menu Utilities MenuHelp Menu Load MIM Port Status DisplaysPort Menus Port Type Status Errors Physical Chassis View Port Status Color Codes Chassis Manager Window Viewing Hardware Types Device Type Setting the Device Date and Time Managing the Hub Resetting Device Counters Restarting the Device Configuring the Front Panel Repeater Port Association Repeater Port Association Setting a Board Name Enabling Boards Enabling and Disabling Ports Viewing I/F Summary Information Index TypeDescription Physical Status Raw Counts Rate Viewing Interface Detail Error AddressUnicast Non-Unicast Unknown Protocol Received only Packets Received Received onlyTransmit Queue Size Transmit only Packets Transmitted Transmit only Testing and Disabling the Current Interface Using the Applications menu Statistics Statistics Accessing the Statistics Windows Statistics Packets Statistics DefinedBytes Using the Total and Delta Radio Buttons Hard ErrorsSoft Errors Collisions Timer Statistics Accessing the Timer Statistics Windows To access the port-level Timer Statistics window Setting the Timer Statistics Interval Summary Statistics Accessing the Summary Statistics Windows Configuring Summary Statistics Accessing the Performance Graph Windows Performance Graph Total Errors Configuring the Performance Graph Source Address Functions Find Source Address Using Port Locking and Unlocking Source Address Functions Lock/Unlock Ports Window Using Source Addressing Setting the Device Ageing Time Device Ageing Time Window Alarm Limits Accessing the Alarm Limits Windows Accessing the Alarm Limits Windows Alarm Limits Collisions Errors of Type Broadcast Packets Within Configuring AlarmsSetting the Alarm Limits Time Interval Setting Alarm Limits Alarm Interval Window Alarm Limits Accessing the Trap Selection Windows Trap Selection Trap Definitions Link State Traps Segmentation Traps Source Address Traps Configuring Traps Accessing the Redundancy Window Redundancy Redundancy Establishing Redundancy Selecting and Naming a Circuit Entering the Physical Addresses of Devices to be Polled Circuit Name Window Assigning Backup Ports and Port Priority to the Circuit Setting the Polling Interval and Number of Retries Polling Interval Window Activating the Circuit Testing the Circuits Reconfiguring a Circuit Test Time of Day Window Changing Port Status Resetting a Circuit Redundancy Reset Warning Window Redundancy Index Index-2 Index-3 Index Index-4