4.If you are removing a display adapter card, you may need to change the settings of jumpers J1 and J2. See page 6-2 for instructions.

5.Replace the cover. See Chapter 5 for instructions.

6.See “Post-installation Setup” at the end of this chapter to configure your computer to operate without the option card.

Adding Memory Modules

Your computer comes with 2MB of memory. By installing SIMMs (single inline memory modules) on the main system board, you can increase the amount of on-board memory in your computer up to 14MB.

Caution

It is best to have your dealer install memory modules for you because they can be damaged easily if installed incorrectly. If you prefer, you can install your own SIMMs by carefully following the instructions in this section. However, you could transmit an electrostatic discharge and damage your components; so read this entire section before you begin.

Before you install SIMMs, check the following guidelines to ensure that they will work properly:

0Use fast-page mode SIMMs that operate at 80ns (nanosecond) access speed (or faster). Be sure all the SIMMs have the same access speed.

0Use the correct SIMM configuration to add the amount of memory you want. See “Installing Memory Modules” on the next page.

Once you have the SIMMs you need, you or your dealer can install them in your computer. If you are going to install them yourself, follow the instructions below.

6-10 Installing and Removing Options