4.Use J or T to highlight the correct capacity for your diskette drive and press Enter. The screen displays the type you selected.

If you want to enter the type for another diskette drive, return to step 3.

5.When the diskette drive settings are correct, highlight

**SAVE SETTINGS ** and press Enter. The cursor

block returns to the main Setup menu and you see the updated information for drives A and B.

Setting the Serial/Parallel Interfaces

The serial and parallel interfaces in your computer are set to act as the primary ports. If you have not added an additional serial or parallel port, you can skip this section.

If you install an option card with its own serial or parallel port, you may want to designate the built-in port as secondary and the additional port as primary. The Setup program lets you choose which port is primary and which is secondary so there is no conflict between the built-in port and the additional port. Here are some guidelines:

If you install an option card with a port pre-set as primary by the manufacturer, you must designate it as the primary port and make the computer’s built-in port the secondary port.

If you install an option card or peripheral with a port that is not pre-set, you can designate it as the primary or secondary

port.

If you install two option cards with ports, designate one as the primary port and the other as the secondary port and disable the built-in port.

2-26 Running the Setup Program