5.Remove the Reference diskette, turn off the computer, and follow the instructions under “Changing the Jumper Settings” in Chapter 6 to enable the password function (jumper J3).

6.If you do not have a hard disk, insert the MS-DOS Startup diskette in drive A. Turn on the computer. You see the key prompt (h ). If you enabled network server mode, you do not see the key prompt. Enter your new password to access the system. (See "Using the Power-on Password” in Chapter 3 or “Using a Password in Network Server Mode” in Chapter 4.)

Note

Be sure to remember your new password or write it down and keep it in a safe place. If you forget the password you enter now, you may have to repeat the procedure above the next time you turn on your computer.

Keyboard Problems

If you are having trouble with the keyboard, check the following:

1.If the screen displays one of the following keyboard errors when you turn on or reset the computer, make sure the keyboard is securely connected to the keyboard socket on the back of the computer:

D 301 Keyboard error

Cl 3 0 3 Keyboard or system unit error O 3 0 4 Keyboard or system unit error.

A-12 Troubleshooting