Disabling the password function

If you do not want to use a power-on password anymore, you can disable the password function. However, if you want to use the password function later, your old password is still stored as the current password. If you want to be able to easily set a password later, follow the instructions in “Disabling an Existing Password,” above.

To disable the password function, follow the instructions under “Changing the Jumper Settings” in Chapter 6 to change the setting of jumper J3.

Setting a New Password

If you have forgotten your current power-on password and want to set a new one, follow these steps:

1.Turn off the computer and follow the instructions under “Changing the Jumper Settings” in Chapter 6 to disable the password function (jumper J3).

2.Insert the Reference diskette in drive A and turn on the computer. You do not see the key prompt.

3.When the Operation Menu appears, highlight Set up and press Enter. Then follow the instructions under “Setting the Power-on Password” in Chapter 2 to enter a new password. (If you want to enable network server mode, highlight Network Server Mode and press Enter to turn on the function.)

Be sure to save your password setting and highlight

**EXIT AND SAVE ** when you leave Setup.

4.After you exit Setup, you see this message:

TURN OFF POWER AND CORRECT JUMPER SETTING TO ENABLE PASSWORD CHECKING

Troubleshooting A-11