If the SIMM does not go in smoothly, do not force it; pull it all the way out and try again.

Make sure the SIMM is fully inserted into the socket and that the pins on the retaining posts protrude through the holes in both ends.

7.Repeat steps 5 and 6 for each SIMM you want to install.

8.Replace any option card(s) you may have removed to access the SIMM sockets. See “Installing an Option Card” on page 6-5 for instructions.

9.Follow the instructions in Chapter 5 to replace the computer’s cover.

10.See “Post-installation Setup” at the end of this chapter for instructions on configuring your computer for use with your new memory.

Removing Memory Modules

If you need to remove memory modules from your computer, have your dealer do it for you or follow the steps below. If you remove them yourself, remember that you must remove both SIMMs from a bank.

Caution

It is safer to have your dealer remove SIMMs for you because there is a danger of transmitting an electrostatic discharge and damaging your components.

1. Remove the cover. See Chapter 5 for instructions.

Installing and Removing Options

6-15