If one of your hard disk drives is already installed in the computer, follow the steps under “Removing a Hard Disk From the Vertical Position,, on page 7-21to remove it. Then set the jumpers on both drives while they are out of the computer.

Note

If you are removing one hard disk drive and leaving one in your computer, be sure to set the jumpers on the remaining drive to indicate that you have only one hard disk drive.

See the table above for the correct jumper settings. Then follow the instructions under ‘Removing a Hard Disk From the Vertical Position,, on page 7-21 so you can access the jumpers on the drive.

Installing a Hard Disk in the Vertical Position

Follow the instructions in this section to install (or reinstall) a hard disk drive in the vertical mounting position. You may need to perform the following procedures:

0 Removing the mounting frames from a new hard disk drive

0Removing the mounting plate from the computer and connecting it to the drive

C3 Installing the drive

0 Attaching the drive cable to the bottom of the subassembly.

If you are installing a new drive in the vertical mounting position, follow all of the steps in this section. If you are reinstalling a drive that you previously removed from this position, see “Installing the Drive” on page 7-12.

Installing and Removing Disk Drives 7-7