5.Check to be sure the power button on the computer is off. Then reconnect the power cable to the back of the computer and to an electrical outlet.

Post-installation Setup for Memory Cards

After you install a memory card in your computer, you need to configure your computer to use it. Follow these guidelines:

Use the Setup program on your Reference diskette to automatically reset your computer’s configuration to include the memory on your installed memory card. See Chapter 2 for instructions.

Use the setup program that comes with your memory card to configure the computer for use with the installed memory card. See your memory card manual for instructions.

If you installed a memory card and you want to use any of its memory as expanded memory, use the EMM386.SYS utility. See “Using Memory Beyond 640KB” in Chapter 4 and your MS-DOS Reference Manual for more information.

Also see “Post-installation Setup” at the end of this chapter for more information on setting up your computer for use with an option card.

To configure your computer for use with the RampagePlus® 286 memory card, you need to use CORFIX, an Epson utility on your Reference diskette, and SMART, the RampagePlus 286 setup program. You must use CORFIX before you use SMART. Follow these steps:

1.Make sure that the computer is on and that MS-DOS is loaded. (See “Loading MS-DOS” in Chapter 4 for instructions.)

Installing Options

5-23