If you have forgotten your password and you do not want to set a new one, there are two ways to remove the current password:
LI Disable the existing password
Ll Disable the password function.
To do either of these procedures, you must reset a jumper on the main system board.
You should disable the existing password if you want to be able to set a new password later without having to reset a jumper on the main system board again. See “Disabling an existing password” below for instructions.
If you disable the password function, you cannot set a new password unless you perform the steps to disable the existing password at that time. If you do not want to use a password anymore, follow the instructions under “Disabling the password function” below.
Disabling an existing password
If you do not know your
1.Turn off the computer and follow the instructions under “Changing Jumper Settings” in Chapter 5 to enable the password skip function by setting jumper J2 to position
2. Insert the Reference diskette into Drive A and turn on the computer. You do not see the key prompt ( C+rrn ).
Troubleshooting