Leaving the Setup Menu

If you want to save the settings you entered, highlight ** EXIT AND SAVE * * and press Enter at a Setup summary screen. The Setup program stores the new settings and resets the computer using the new configuration. If you have set a password, you need to enter it at the key prompt. (See “Using a Power-on Password” in Chapter 3 for instructions.) The Operation Menu appears. Press 0 and Enter to exit the Operation Menu.

If the computer displays an error message while it is starting up, run the Setup program again and check the setting the error message indicates. If the computer still displays an error message after you check your Setup program settings, see Appendix B or ask your dealer for assistance.

Note

If you did not change any settings or you want to cancel the changes you made, highlight Exit without saving at a Setup summary screen and press Enter, The Operation Menu appears. Press 0 and Enter to exit from the Opera

Menu. (If you changed the time or date, the new setting takes effect even if you exit the Setup program without saving your changes.)

After you save the settings you entered, remove the Reference diskette from your diskette drive and turn off your system. Then follow the instructions in your MS-DOS Installation Guide to install MS-DOS.

Note

Be sure to make a backup copy of your Reference diskette after you run the Setup program and install MS-DOS. See

Chapter 3 for instructions on how to copy diskettes,

2-28 Running the Setup Program