Caution:
Don’t use an outlet controlled by a wall switch or timer, or one that uses the same circuit as a large appliance. This may disrupt the power, which can erase memory or even damage the power supply.
Using the Ethernet Card
Initializing the Ethernet Card
You only need to initialize the card under the following conditions:
◗The first time you connect the printer to a network.
◗EPSON Net! cannot recognize the card because its settings are incorrect.
◗You reinstall the card in a different printer.
To initialize the card, make sure the printer is turned off (the power button should be up) and plug the printer into a properly grounded outlet while pressing down the status sheet button for at least three seconds.
status sheet button
To reset all card configuration settings to their factory defaults, turn the printer on while pressing the status sheet button on the card plate.
Configuring for DLC on
Windows NT 4.0
If you use Windows NT 4.0, the Ethernet card works with the DLC (Data Link Control) protocol provided in your operating system. Follow the instructions below to install DLC protocol and configure the Ethernet card to use it.