Using the Ethernet Card

7.Select the target node address from the Card Address list. Make sure this address matches the one listed under Node Number on the status sheet.

8.Click the Timers button and select the Job Based option. Then click Close.

9.Click Next, then follow the instructions on the screen for the DLC printer driver installation.

Configuring for OS/2

To use EPSON Net! to configure the card, you must have OS/2 Warp Connect or Server with NetBEUI or NetBIOS over TCP/IP.

EPSON Net! for OS/2 provides the following programs:

NetBEUI

RPRINT3, RSTAT3—LPT redirection REMPRT3, REMBEU, REMSTAT3—pipe support

TCP/IP

RPRINT, RSTAT—LPT redirection

REMPRT, REMSTAT—pipe support

Setting Up Redirection to the Printer

To redirect the workstation’s ports to your printer, print a status sheet for the Ethernet card to obtain the card’s serial number as described on page 6-3, then follow these steps:

1.Insert the EPSON Stylus COLOR 850N CD-ROM in your workstation’s drive.

2.Open an OS/2 full screen command session.

6-7