Using the Ethernet Card

If several ports are redirected, RSTAT returns a message similar to the following:

ITC Remote Print Servers active for LPT1—Printer Busy

ITC Remote Print Servers active for LPT2—Printer Ready

ITC Remote Print Servers active for LPT3—Printer Ready

Setting Up Piping to the Printer

To set up piping, you first need to copy the piping software to your computer, then configure the printer and check its status.

Copying the Piping Software

Print a status sheet following the instructions on page 6-3 to obtain the card serial number. Then follow these steps to copy the piping software to your computer:

1.Insert the EPSON CD-ROM or diskette into your workstation’s drive.

2.Open an OS/2 full command session.

3.Create a remote print service directory by typing MD C:\EPNET at the command line.

4.Open the OS/2 directory on the CD-ROM or diskette and go to the PIPES directory for your network protocol.

◗For TCP/IP, type CD TCPIP\PIPE and press Enter.

◗For NetBEUI, type CD NETBEUI\PIPE and press

Enter.

6-9