10. Adjust the right paper guide so that it matches your paper’s width.

A

Make sure the position of the guide allows the paper to move up and

down freely. Then push the lock lever backward to lock the paper guide.

11.Push back the paper set levers to clamp the paper against the guide rollers.

12.Move the cut-sheet feeder’s paper selection lever to the single-sheet position, as shown below. Then lift up the center support and close the paper guide cover.

continuous paper position

single-sheet position

Note:

❏Always close the printer cover before printing. The printer does not print when the cover is open.

❏When the cut-sheet feeder is installed, you can still load single sheets one at a time using the front paper slot.

The cut-sheet feeder automatically loads paper when the printer receives data. Printed pages are stacked on the center support. If you need to eject a sheet, press the Load/Eject button.

If the first printed line on your page appears too high or low, you can adjust its position using the micro adjust feature. See “Adjusting the Top-of-Form Position” on page 2-36.

cCaution:

Never use the knob to adjust the top-of-form position; this may damage the printer or cause it to lose the top-of-form position.

Enhancing Your Printer With Options A-9