12.If you use the front slot, attach the front paper guide with the continuous paper positioned as shown below. Then close it.

If you use the rear slot, replace the paper guide and make sure

the edge guides are together in the middle of the paper guide. 2

13.Turn on the printer.

14.Remove any slack in the paper and adjust the top-of-form position (the position where the printer will start printing) by pressing the LF/FF button or using the micro adjust feature. (To use the micro adjust feature, see “Adjusting the Top-of-Form Position” on page 2-36.) The printer will start printing at the current position without advancing the paper.

c Caution:

❏Never use the knob to remove slack in the paper or to adjust the top-of-form position; this may damage the printer or cause it to lose the top-of-form position.

❏Always remove any slack from the paper; otherwise print quality may be reduced.

Printing on Continuous Paper 2-27