4.Slide the left sprocket to the left margin of the paper using the scale on the printer. (Printing starts at the “0” mark.) Then push the lever back to lock it in place.
front of the printer
Note:
See “Paper alignment” and “Printable area” in Appendix C for more information on the left margin position.
5.Slide the right sprocket to match the width of your paper, but do not lock it. Move the paper support midway between the two sprockets as shown above.
6.Open both sprocket covers. Make sure your paper has a clean, straight edge and fit the first four holes of the paper, printable side down, over the tractor pins. Then close the sprocket covers.
front of the printer
7.Slide the right sprocket to remove any slack in the paper; then lock it in place by pushing the sprocket lock down.