Using the Front Push Tractor
To use the front push tractor, load continuous paper in the front slot. For more information on when to use the front push tractor, see “Available Paper Paths” on page 3.
Note:
The tractors are installed in the front push and rear push positions when the printer is shipped. The rear push tractor cannot be removed.
Installing the tractor in the front push position
If a tractor is installed in the front push position, skip to “Loading paper onto the front push tractor“ on the next page.
If a tractor is installed in the pull position, you need to remove it, and replace the paper tension unit as described on page
To install the tractor in the front push position, follow these steps:
1.Make sure the printer is turned off.
2.Open the front paper guide by pulling the tab at the center of the guide. Then remove the guide by grasping both sides and pulling it straight out of the printer.
tab