❏Unplug the printer and refer servicing to qualified service personnel under the following conditions:

If the power cord or plug is damaged; if liquid has entered the printer; if the printer has been dropped or the cabinet damaged; or if the printer does not operate normally or exhibits a distinct change in performance. Adjust only those controls that are covered by the operating instructions.

❏

Printer parts marked with this symbol may be hot.

 

K Turn off the printer and let it cool for a few minutes

 

before you touch any printer part marked with this

 

symbol.

❏If you plan to use the printer in Germany, observe the following:

To provide adequate short-circuit protection and over- current protection for this printer, the building installation must be protected by a 16 Amp circuit breaker.

Note for German-speaking users:

Bei Anschluß des Druckers an die Stromversorgung muß sichergestellt werden, daß die Gebäudeinstallation mit einem 16 A-Überstromschalter abgesichert ist.

Print Head Caution Symbol

The symbol on the print head indicates that this

K

part may be hot. Never touch the print head just

after the printer has been used. Let the print head

cool for a few minutes before touching it.

Getting to Know Your Printer 12