Insert this type of form in the front slot with the bound edge first and the printable side up, as shown below.

3

printable side up

You can load multi-part forms bound at the side only in the front slot. Insert this type of form in the front slot with the top edge first and the printable side up, as shown below.

printable side up

Before printing, set the paper thickness lever (located under the printer cover) to the proper position for your paper. See the table on page 3-3.

Be sure your multi-part forms do not exceed 0.46 mm (0.018 inch) in thickness.

Use multi-part forms only under normal temperature and

humidity conditions, as follows:

Temperature

15 to 25°C (59 to 77°F)

Humidity

30 to 60% RH

Printing on Single Sheets

3-5