Epson TM-FX2180 manual Main Menu

EPSON FX-2180 Service Manual

After you select the factory setting, you see the Main menu.

Program : J******		Setting : *****
9 pins VR 0 = 0		VR 1 = 0	VR 2 = 0
[	Main MENU	]
(1)	Bi-d Adjust	(6) Envelope
(2)	FF paper	(7) ---- N/A ----
(3)	A3 Cut sheet	> (8) -- SUB MENU

(4)A4 1P Cut sheet

(5)A4 6P Cut sheet

Figure 5-17. Main Menu

6.Use the − or ↓ key to highlight SUB MENU and press Enter. You see the following submenu:

Program : J******		Setting : *****
9 pins VR 0 = 0			VR 1 = 0	VR 2 = 0
[	Sub MENU	]
(1)	Memory SW Print		(6) EEPROM Print
(2)	EEPROM Reset		(7) -- EXIT

>(3) TPE Adjust

(4)Pitch 1P

(5)Pitch 20P

Figure 5-18. Submenu

7.Use the − or ↓ key to highlight TPE Adjust and press Enter.

8.Insert an A4-size sheet of paper into the printer’s rear paper guide. Make sure the paper is positioned in the portrait orientation. The TPE check pattern and the current TPE position value is printed, as shown in Figure 5-19.

Chapter 5 Adjustments

9.Measure the distance from the top of the paper to the 0 level line, as

shown below. Check whether the distance equals 0.335 inches

± 0.020 inches (8.5 mm ± 0.5 mm).

TOF

-9 -6 -3 0 3 6 9

TPE position = 00,

Figure 5-19. TOF Measurement

After the page is printed, you see the following menu:

<TPE adjustment > TPE Pos. = 0

Exit	Print	Value	Write	Default
[ESC]	[SPACE] [	(0-9)]	[RET]	[HOME]

Figure 5-20. TPE Adjustment Menu

10.If your TOF measurement is not equal to 0.335 inches ± 0.020 inches (8.5 mm ± 0.5 mm), use the − or ↓ key to change the TOF value. Then

press Enter.

5-9