Epson TM-P60 with Peeler is near something that makes noise, There are problems with the PC

TM-P60 with Peeler Technical Reference Guide

A 6.4 TM-P60 with Peeler is near something that makes noise.

Communication may be difficult near a microwave or motor. Move the AP or TM-P60 with Peeler and confirm that communication is possible away from anything that makes noise.

A 6.5 Confirm TM-P60 with Peeler is turned on.

Turn on the TM-P60 with Peeler.

A 6.6 Reset the TM-P60 with Peeler to the default setting.

Reset the TM-P60 with Peeler to the default setting (see “Resetting the printer” (page 3-5)). Then set up from the first step (see “Installing your wireless LAN” (page 2-14).)

A 6.7 There are problems with the PC.

If you have another PC available for setting, exchange the other PC with your current PC and retry setting.

A 6.8 Confirm the AP (in infrastructure mode)

❏Confirm that AP is turned on.

❏Confirm the setting for the wireless LAN function of the AP or PC. Confirm that the wireless LAN function or RF is turned on.

❏Confirm that the cable between the network and AP is not unplugged or cut.

Q 7. Wireless LAN parameters for the TM-P60 with Peeler cannot be set with RS- 232

When setting the TM-P60 with Peeler with RS-232, TMNetWingConfig must be installed on the PC. Also, the serial setting of TMNetConfig must match the TM-P60 with Peeler.

A 7.1 Turn on the TM-P60 with Peeler again.

After confirming the that TM-P60 with Peeler is connected with the serial cable to the PC, turn the TM-P60 with Peeler on again.

A 7.2 The serial cable is not specified by EPSON.

Use a serial cable that EPSON specifies. Communication is not guaranteed with any cable except the specified cable (OT-RS6).

A 7.3 The COM setting for the TM-P60 with Peeler does not match that of the PC.

Select “COM” in the “SearchPass” option of TMNetWinConfig and set the COM setting to meet the setting of the PC. and set the seiral communication conditon with “search option COM“ to match the TM-P60 with Peeler’s condition. The condition of TM-P60 with Peeler can be confirmed by self test; see “Self test mode” (page 3-3).

A 7.4 The TM-P60 with Peeler is turned OFF.

Turn ON the TM-P60 with Peeler.

Rev. B FAQ E-3