Extron electronic AVT 200HD manual Audio Output Connectors, Analog audio output connectors

EHDMI video output connector — Connect an HDMI output device to this female HDMI connector for digital video output. This output supports 480p, 720p, and 1080i resolutions. The table below shows the pin assignments for this connector.

Pin	Signal	Pin	Signal	Pin	Signal	19			1
1	TMDS data 2+	7	TMDS data 0+	13	CEC
2	TMDS data 2	8	TMDS data 0	14	Reserved	18			2
	shield		shield		(NC on device)
									HDMI
								Type A Receptacle
3	TMDS data 2–	9	TMDS data 0–	15	SCL
							1		19
4	TMDS data 1+	10	TMDS clock+	16	SDA
5	TMDS data 1	11	TMDS clock	17	DDC/CEC
	shield		shield		ground
						2			18
6	TMDS data 1–	12	TMDS clock–	18	+5 V power
									HDMI
								Type A Plug
				19	Hot plug
					detect

An Extron LockIt™ cable lacing bracket is provided with the AVT to enable you to secure the HDMI device cable to this output connector to prevent intermittent or complete signal loss due to a loose cable connection. Above the connector is a hole into which an HDMI connection mounting screw (provided) can be inserted to attach the lacing bracket to the AVT rear panel. (See the provided LockIt HDMI Lacing Bracket Installation Guide card for information on attaching the bracket.)

Figure 3. HDMI Connector Pin Assignments

Audio Output Connectors

Analog audio output connectors

FAudio output RCA connectors — Connect a speaker set or other audio output device to these RCA connectors for balanced or unbalanced analog audio output.

Tip (+)

Sleeve ()

Figure 4. Wiring an RCA Connector

GAudio output captive screw connector — Connect a speaker set or other audio output device to this 3.5 mm 5-pole captive screw connector for balanced or unbalanced analog audio output (see the illustration on the next page).

AVT 200HD Tuner • Installation 6