2.Press the Enter button to implement the channel or preset selection.
•If the number you entered is a valid channel or an existing preset number, the AVT switches to it, and the number is displayed on the LED panel, aligned with the right position in the field (shown in the example below).
The default cycle on the LCD screen displays the new channel number with a hyphen instead of a decimal point (shown in the example below).
KRZY–DT
AIR 28–1
•If you enter an invalid channel or preset number, the LED display blinks three times, then returns to the channel number that was displayed previously (the display on the LCD does not change). The channel or preset is not changed.
Locking IR Remote Control Access
The AVT 200HD Remote Control can be set to lock out users from using it to control the AVT. This is done by selecting the IR LOCKOUT from the front panel Exec Mode Select menu (see “Locking and Unlocking the Front Panel (Executive Modes),” earlier
in this section); SIS commands (see the executive mode commands in the “Remote Configuration and Control” section); the web pages (see “Tuner Settings Page“ in the “HTML Configuration and Control” section); or the
Using the On-screen Display (OSD)
The AVT 200HD provides a translucent
NOTE: The OSD screens are for viewing only. You cannot make selections from them.
Introductory Display
Whenever you change a channel, a translucent display pops up on the television screen, showing the following information:
•Channel number
•Channel name
•Program title
•Time of day
•Signal strength
This same display appears when you power on the AVT if it is connected to a display that is already powered on. You cannot disable this introductory display. After approximately 5 seconds, the display disappears.
AVT 200HD Tuner • Operation | 36 |
